1. Place the sample in the testing rack and press down on the battery cells to prevent them from being pulled during the peeling test and affecting the test data.

2. Move the displacement device to the appropriate position and gently place the welding tape into the fixture.

3. Set software parameters: Positive qualified force value: 0.8

Back qualified force value: 1.2

Operating speed: 200mm

Qualified ratio: 70% (for example, at the 6-point position, even if there are two virtual welds during operation, it is considered qualified and can be set according to the actual situation)

4. Select the corresponding sampling file (different lines, different solder joint positions, different peak sampling points, different sampling points on the back and front)

5. Click to run.