1. The instrument should be placed on a flat ground, with a clean and tidy environment, dry and ventilated;
Before using the instrument, all control switches should be in a non working state, and the speed control knob should be placed in the Z small position;
3. Do not adjust the pressure of the incoming gas too high to avoid breaking the pipeline and damaging the detector;
4. Close the door of the incubator to prevent gas leakage and affect the test results;
Before each shutdown, all control switches should be in a non working state before cutting off the power supply;
At least 3 people need to know the password setting to avoid forgetting the password and being unable to turn on the instrument;
7. The gas in the steel cylinder must be pure and meet the standard to avoid damaging the instrument;
8. Keep the air inside the incubator clean and disinfect it regularly;
9. Regularly pay attention to the amount of distilled water in the distilled water tank inside the box to maintain relative humidity and avoid evaporation of the culture medium;
10. Not applicable to the cultivation of items containing volatile chemical solvents, low concentration gases, low ignition point gases, and toxic substances.
11. Proper use and maintenance of instruments can prolong their service life by keeping them in good working condition;
After the refrigeration system stops working, clean the working chamber and glass observation window with a soft cloth;
13. During continuous operation, the instrument should undergo regular inspections every three months; Check for water droplets, dirt, etc. falling onto the motor and exposed refrigeration components; Clean the dust and dirt on the compressor and condenser; Check fuses, control components, and fastening screws;
14. After long-term use, natural wear and tear of the instrument is a normal phenomenon, and the manufacturer should be contacted for maintenance.