Structure Overview:

1. This machine mainly has a rack Bearing seat fixed machine foot, motor, hard tooth reducer, roller, bearing, safety switch The cooling device, as well as electrical control and other components.

2. The transmission system of this machine is connected by an electric motor and a reducer, which drives the front and rear roller speed ratio gears to work at a certain speed ratio through the output of the reducer.

3. This machine is equipped with a cooling device Cooling the roller with cooling water to meet the process requirements.

4. In order to prevent the rubber material from being squeezed into the bearing parts of the roller from both ends, movable rubber plates are installed at both ends of the roller

5. The adjustment of roller spacing is done through a handwheel Install a digital display in front of the machine handwheel to adjust the required roller distance The specific film accuracy is measured using a caliper Adjust by fine-tuning with the handwheel.

6. The safety device of this machine is equipped with a knee press safety device on the front of the machine. If there is danger, use your knee to press the emergency stop button plate, and the roller will stop rotating safely.