Low speed freeze centrifugeUsage environment:

To ensure the safety of continuous use of the machine, the following factors may damage the centrifuge:

- Chemical effects

Environmental impacts, including natural ultraviolet radiation.

Corrosion and wear of protective cover components and other safety components.

1For indoor use

2. Altitude: ≤ 2000m

3. The applicable temperature range for instrument operation is+5 ℃ to+40 ℃

4. The relative temperature range suitable for instrument operation is ≤ 80%

5. Scope of application of instrument working power supplyAC230V 50HZ/60HZ 15A

6. Adequate ventilation equipment must be installed indoors

7. There are vibrations and airflows around that do not affect performance

8. There is no conductive dust, explosive gas, or corrosive gas present in the surrounding air.

Low speed freeze centrifugePlacement requirements:

1This machine should be placed on a sufficiently rigid horizontal table and kept away from vibration and impact equipment, avoiding direct exposure to heat sources and sunlight.

2There should be 1 on all four sides of this machineA space of 0 cm to 15 cm for machine ventilation and heat dissipation.

3After placement, the level should be adjusted and the four support feet at the bottom of the equipment should be evenly supported on the table.

4Scope of application of instrument working power supplyAC230V 50HZ/60HZ 15A。

This machine must be strictly and reliably grounded, and the machine power grounding wire must be reliably connected to the grid grounding wire! It is strictly prohibited to manually cut off power during the operation of the rotor, otherwise it may cause damage to the control circuit!