Intelligent Bacterial Collector Operation Video

Introduction to Intelligent Bacterial Collector:
The test sample is subjected to directional peristaltic pressure through an intelligent bacterial collection instrument, and a positive pressure filter is implemented and cultured inside the filter to verify whether the test sample contains bacteria. The test sample is injected through injection
The pipeline is continuously injected into the intelligent bacterial culture device, and the downward pressure formed in the bacterial culture device is utilized to filter through a microporous membrane. Microorganisms that may exist in the test sample are intercepted and collected
On the filter membrane, remove the antibacterial components of the test sample by rinsing the filter membrane. Then inject the required culture medium directly into the bacterial collection incubator through the injection pipeline, place it at the specified temperature for cultivation, and observe whether there is any growth of bacteria.
Operation Instructions:
1. Take out the incubator and check if the packaging is intact. Open the plastic packaging bag in the sterile room.
2. Insert the incubators one by one onto the stainless steel seats.
3. Install the elastic hose of the bacterial culture incubator into the pump head of the intelligent bacterial collection device, ensuring accurate positioning and smooth movement of the hose.
4. Open the bottle cap insertion hole of the sample to be tested and disinfect it (if testing ampoule samples, disinfect the neck of the ampoule first, then open and position the ampoule).
5. Remove the sheath of the dual core injection tube, insert it into the sample bottle, turn on the bacterial collector, and perform filtration and bacterial collection (avoid air intake into the dual core injection tube, as the filter membrane may be soaked by the drug solution and affect air intake).
6. After completing the bacterial collection, if the sample contains antibacterial substances, it should be washed with appropriate rinsing solution according to the pharmacopoeia specifications, and the cleaning method should be the same as the bacterial collection process.
7. Disinfect the insertion hole of the culture medium bottle.
8. Remove the rubber plug from the top air filter opening and place it on the bottom of the incubator. Use a hose clamp to sequentially open and close the hose, turn on the bacterial collector, and pump the culture medium into the incubator.
9. Use a clip to clamp the hose connected to the incubator, leaving a 5-6cm hose, cut off the remaining part, and insert the open end into the air filter opening.
10. Cultivate according to regulations separately.
11. Observe the cultivation situation. If sampling, separation and cultivation are required, the hose can be disinfected and sterile injection can be used.