Single cell ceramic fixturean instruction manual:

1、 Product Overview

　　Single cell ceramic fixtureIt is a specialized tool used to fix and support single cells for testing, made of high-temperature and corrosion-resistant ceramic materials, suitable for complex testing environments such as high temperature and high pressure. This product has the characteristics of compact structure, easy operation, and accurate testing, and is widely used in the testing of solid oxide fuel cells (SOFC), solid oxide electrolysis cells (SOEC), and other fields.

2、 Product composition

The single-cell ceramic fixture mainly consists of a ceramic body, sealant, electrode connectors, gas inlet and outlet, etc. Among them, the ceramic body is made of high-temperature resistant ceramic materials such as alumina, which has good high-temperature resistance and chemical stability; Sealing glue is used to seal the gap between the battery and the fixture, preventing gas leakage during the testing process; Electrode connectors are used to connect batteries and testing instruments to ensure accurate transmission of current; Gas inlet and outlet are used for introducing and discharging test gases.

3、 Usage method

preparation:

Check if the fixture is intact and undamaged, ensuring that the ceramic body, sealant, electrode connectors, and other components are free of cracks and damage.

Clean the surface of the fixture, remove impurities and stains, and ensure the cleanliness of the fixture.

Prepare the single battery to be tested, ensuring that the surface of the battery is flat and free of scratches.

Install battery:

Place the battery inside the ceramic body of the fixture, ensuring that the contact surface between the battery and the fixture is flat and tight.

Seal the gap between the battery and the fixture with sealant to ensure good sealing performance.

Connect the electrode connectors and connect the battery to the testing instrument to ensure accurate transmission of current.

Test operation:

Place the fixture in the testing system, connect the gas inlet and outlet, and introduce the testing gas.

Open the testing instrument, set the testing parameters, and start the test.

During the testing process, pay attention to observing the status of the fixtures and batteries to ensure safe testing.

After the test is completed, turn off the testing instrument, disconnect the gas inlet and outlet, and remove the fixture and battery.

4、 Precautions

Before use, please carefully read this manual to understand the structure and usage of the fixture.

When installing and replacing batteries, please ensure the accuracy and stability of the fixture to avoid affecting the test results.

During the testing process, please pay attention to the status of the fixtures and batteries. If any abnormalities are found, please stop the testing in a timely manner and check the cause.

Regularly clean and maintain fixtures to maintain their cleanliness and service life.

Avoid using fixtures for testing in environments that exceed their high temperature resistance and chemical stability to prevent damage to the fixtures and batteries.

5、 Maintenance and upkeep

After each use, please clean the fixture to remove impurities and stains.

Regularly check the sealing performance and electrical connection of the fixture to ensure its normal operation.

If cracks or damages are found in the fixture, please replace it with a new one in a timely manner.

When not in use for a long time, please store the fixture in a dry and ventilated place to avoid moisture and corrosion.

6、 Safety Tips

During the testing process, please pay attention to personal protection to avoid harm to personnel caused by dangerous factors such as high temperature and high pressure.

Do not conduct testing unattended to avoid accidents.

During the testing process, if any abnormal odors, smoke, or other conditions are found, please stop testing immediately and investigate the cause.