1Solar simulator testing systemUse core prerequisites

Before use, it is necessary to confirm that the equipment installation is compliant, the power supply is stable, and the environmental temperature and humidity meet the equipment requirements (usually 15-35 ℃, humidity ≤ 80%), in order to avoid affecting the testing accuracy.

2、 Basic operation steps

Power on preparation: Connect the power and signal cables, turn on the main controller, and wait for the device self-test to complete (green indicator light indicates normal).

Parameter setting: According to the testing requirements, select the simulated spectrum type (such as AM1.5 standard spectrum), irradiance value (commonly 1000W/m ²), and testing duration in the control system.

Sample placement: Fix the tested sample at the center of the testing platform, ensuring that the sample surface is parallel to the light source illumination surface and free from obstruction interference.

Start testing: After confirming that the parameters are correct, click "Start Testing", and the device will automatically run and record data. During the testing process, avoid touching the test bench.

Shutdown process: After the test is completed, first turn off the light source module, wait for the device to cool down for 5-10 minutes, then turn off the power of the main controller and disconnect the cable.

3、 Precautions for use

Do not open the light source protective cover while the device is running to avoid direct exposure to strong light that may cause eye injury.

Regularly clean the dust on the light source outlet and test bench surface to avoid affecting the uniformity of irradiation.

If abnormal alarms occur during testing (such as overheating or excessive irradiance), the machine should be stopped immediately for inspection and troubleshooting before it can be reused.

4、 Common problem handling

Non irradiation output: Check if the power connection is normal, if the light source module is in standby mode, and try restarting the device.

Large data fluctuations: Confirm whether the environment is stable, whether the sample is firmly fixed, and if necessary, recalibrate the equipment irradiance.