Multi color plant incubatorIt is a professional equipment that provides controllable conditions for plant growth, tissue culture, and photosynthesis research by accurately regulating the combination of multiple monochromatic light sources and simulating different natural light environments. It is widely used in fields such as agricultural science, biotechnology, horticultural breeding, and university research. Its core function is to meet the specific needs of different plants (or different growth stages of plants) for light by adjusting light quality, light intensity, light cycle, and temperature and humidity. It helps to study the effects of light environment on plant physiological metabolism, morphological construction, or cultivate high-quality seedlings.

　　Multi color plant incubatorRegular maintenance (weekly, monthly, or by frequency of use):

1. Deep cleaning:

Perform more thorough internal cleaning, including corners and gaps.

Removable shelves and trays should be taken out for separate cleaning and disinfection (alcohol spray or UV irradiation can be used).

2. Clean the LED light board:

Importance: Dust can reduce light output efficiency and affect light intensity.

Method:

power failure!

Gently brush off the dust on the surface of the lamp board with a dry and soft brush (such as a lens brush) or a balloon.

If there are stubborn stains, they can be carefully wiped with a dry cotton swab or a cotton swab dipped in a small amount of anhydrous ethanol (be sure to wring it out to avoid liquid dripping), and immediately wiped dry with a dry cotton swab.

It is strictly prohibited to rinse directly with water or wipe extensively with a damp cloth to prevent short circuits.

3. Maintain door seal (sealing ring):

Purpose: To ensure the airtightness of the box, prevent heat exchange and humidity leakage.

Method: Wipe the door seal with a damp cloth to remove dirt. Check for aging, deformation, cracks, or adhesion. If there is any damage, it needs to be replaced in a timely manner. After cleaning and drying, a thin layer of silicone grease can be applied to maintain elasticity (not necessary).

4. Check the sensor:

Temperature and humidity sensor: Gently wipe the probe with a clean cotton swab to remove dust or moisture condensation. Standard temperature and humidity meters can be used for calibration and verification.

CO ₂ sensor (if any): Perform zero calibration or regular inspection according to the manual requirements.

5. Clean the condenser and ventilation openings:

Location: Usually on the back or bottom of the box.

Method: Use a vacuum cleaner or soft bristled brush to remove dust from the heat sink. Maintain good ventilation around, stay away from walls and obstacles, and ensure efficient heat dissipation.

6. Check electrical connections:

Check if the power cord and plug are damaged or aged.