Instructions for using a constant temperature water bath

1 Before use, an appropriate amount of clean tap water must be added to the pot,Hot water can also be added at the desired temperature,To shorten the heating time.

2、 Connect the power and select the temperature. Digital display meter head, counter*The major digit is a ten digit number, with the operation symbol indicating an increase and the operation symbol indicating a decrease. Traffic lights switch with changes in body temperature. also,The green light indicates that the heater is working, while the red light indicates constant temperature. The use of this instrument requires heating and constant temperature at least twice to achieve the correct temperature accuracy(It must be fully covered and sealed before it can be achieved).

3、 Work done,Place the temperature control knob and controller in*Small value, cut off the power.

4、 If you want the water temperature in the pot to reach100CWhen used for boiling water distillation, the adjustment knob can be adjusted to the endpoint.

5、 Do not add too much water to prevent the water from overflowing outside the pot when boiling,

6、 The amount of water in the pot should not be less than half, and the heating tube should not be exposed to the water surface. To avoid burning out, causing water and electricity leakage.

7、 When using this product, the three pin socket must be effectively grounded.