Sliding Friction and Wear TesterUnder a certain contact pressure, it can simulate rolling, sliding, or sliding rolling composite motion, and complete point, line, and surface friction simulation tests. Can be used to evaluate the friction and wear properties of lubricants, metals, plastics, coatings, rubber, ceramics, and other materials. It can meet the needs of traditional petrochemical industry users for research, development, and testing of various series of hydraulic oils, internal combustion engine oils, and gear oils, as well as the needs of users for simulation evaluation and testing in emerging material development and new process research.
The sliding friction and wear tester introduces process control principles and tightly integrates industrial control computers with configuration software technology and network technology; And adopting an integrated structural design, the embedded industrial control computer, configuration software, acquisition module, and actuator are combined in one framework to complete the control of the entire experimental process. All experimental operations can be carried out in the main interface of the computer. It is a friction and wear testing machine that applies this technology in China. It has the characteristics of flexible configuration control, multiple types of friction pairs, large speed range, ability to simulate high temperature environment, high degree of automation, and convenient use and adjustment.
Sliding Friction and Wear TesterPrecautions for use
1. Adjust parameters: Verify the displayed values of friction and test force, use them carefully, and have password protection
2. Zero point adjustment: Adjust the hardware zero point (already set before leaving the factory, users do not need to modify it)
3. Calibration Friction Force: Used to calibrate friction force (already set before leaving the factory, users do not need to make any changes)
4. Back end parameters of friction and wear testing machine: The manufacturer sets the back end parameters at the factory, and users do not need to modify them. After modification, it will display garbled text and inaccurate measurement data.
When adding a lot of data and the system crashes, do not perform any operations on the computer
6. Test personnel should not stay too far away from the testing equipment during the test or directly carry out operations other than the test. Sometimes, when the unloading of the test force reaches the limit and does not stop actively and continues, it must be manually stopped through emergency stop.
7. When conducting room temperature tests, do not connect the plug of the heating equipment to the socket of the friction and wear testing machine.
The above is aboutSliding Friction and Wear TesterThe classification and precautions during operation of the testing machine must be followed by operators in accordance with the instructions for standardized use. Otherwise, it is easy to cause machine malfunctions and personnel injuries and other dangerous situations.